Articles search results for fuel sender

Showing 1 to 5 of 5 articles

I'm often asked about the range of cylinder heads I do for Mini Spares/Mini Mania, so here's the low-down…

Although the following range of heads accommodate specific fitments - like pre-1992 where by-pass hoses and heater take-offs on the clutch end of the head are used and post-1992 where neither of these exist, and on SPi (single point injection) heads where they don't usually have a threaded hole for the temperature sender - in reality it is easy to convert almost any of them to fit any other engine since holes are easily blocked off - or by-pass hoses not used, water pumps blanked off and drilled thermostats fitted (see articles on cooling/engine transplants). A list of which is what and what to do to each to convert is at the end of this article.

For more in-depth descriptions of the head specs, see article 'Cylinder head - About Min Tec Heads' - basically the valve sizes used have been decided on after extensive and in-depth flow test...

Is this familiar? - You take the small one out; you put the big one in. In, out, in, out, shake your fist about, you do the hokey-cokey and you turn around, that’s what it’s all about...

Terminology -
BBU - Big Bore Unit
SBU - Small Bore Unit
Bodge - English term for 'make do' engineering- assured to fail at an in opportune
Moment.
Dizzy - Distributor

NOTE; this information is largely for transplanting large-bore units into small-bore engined cars.

Is this familiar? - You take the small one out; you put the big one in. In, out, in, out, shake your fist about, you do the hokey-cokey and you turn around, that’s what it’s all about...kinda sums up the situation many folk find themselves in when attempting to endow their beloved Min with a more impressive turn of speed.

Lubrication - Oil, what it does and how

It's criminal. Folk spend fortunes putting together super-sonic motors, only to skimp on the oil they use. Why? Oil's oil right? Wrong. Even if it's a standard engine, it deserves TLC considering it's extremely hostile working environment.

Oil is literally the engine's life-blood. The opening few sentences are astonishingly true. Oil isn't there just to prevent all metal components within an engine fusing together in the first few seconds of running, creating a total melt down of Chernobyl proportions. It's an intricate blending of chemicals to protect the engine as a whole.

The most commonly uttered statement about engine wear is most wear occurs within the first 10 minutes from start up when cold. True if cheap chip fat oil is used.In performance and race engines, a considerable amount of wear is created by heat, load, speed, and pressure. Again, cheapy oil won't give protection here.

Choice of radiators